I just made a tube for developing 8x10 film in, out of ABS black plastic
pipe. I did it according to the directions in the Beyond the Zone System
book. It worked pretty well, held liquid well, etc, but when I withdrew the
film from the tube it scratched the non-emulsion side pretty badly with two
long scratches. I felt around inside the tube but couldn't feel any big
sharp places or anything. I had sanded some inside. Any clue as to what
caused these scratches? maybe residual sand from the sandpaper?
--shannon
Received on Sat Jun 1 23:55:58 2002
This archive was generated by hypermail 2.1.8 : Mon 13 Dec 2004 - 23:18:45 PST