I think Kurt's address is: krm@cnsp.com
andy
-----Original Message-----
From: pinhole-discussion-admin@pinhole.com
[mailto:pinhole-discussion-admin@pinhole.com]On Behalf Of William
Erickson
Sent: Wednesday, October 25, 2000 9:02 PM
To: pinhole-discussion@pinhole.com
Subject: Re: [pinhole-discussion] Curved Film Plane Pinhole Panos --
construction quesry
It's dramatically easier if you use paper rather than film for the negative.
if you use film, use very large format and make contact prints. There are
threads in the cameramakers group archives on the problems of curving film
planes. Kurt Mottweiler is the guru of curved film. I don't have addresses
but you can search.
----- Original Message -----
From: <GAPiccagli@aol.com>
To: <pinhole-discussion@pinhole.com>
Sent: Wednesday, October 25, 2000 4:46 PM
Subject: [pinhole-discussion] Curved Film Plane Pinhole Panos --
construction quesry
>
> In a message dated 10/25/00 8:07:56 AM,
pinhole-discussion-admin@pinhole.com
> writes:
>
> << From: "William Erickson" <erickson@ic.mankato.mn.us>
> Simple panorama camera can be made out of cardboard. Make one side flat =
> and all the rest a half circle. >>
>
> I'm quite interested in the notion of curved film plane pano pinhole
cameras,
> but have not been clear about accessible ways to construct the curved film
> plane. I've seen multiple examples. Any experience on 1) what's sufficient
> for a mock-up, and 2) what is best without access to a sophisticated
machine
> shop? (presumably 2 different approaches)
>
>
> Giorgio Piccagli
> Bent in San Francisco
>
> _______________________________________________
> Pinhole-Discussion mailing list
> Pinhole-Discussion@pinhole.com
> unsubscribe or change your account at
> http://www.pinhole.com/discussion/
>
_______________________________________________
Pinhole-Discussion mailing list
Pinhole-Discussion@pinhole.com
unsubscribe or change your account at
http://www.pinhole.com/discussion/
Received on Wed Oct 25 22:02:33 2000
This archive was generated by hypermail 2.1.8 : Mon 13 Dec 2004 - 23:15:56 PST