RE: where 2 measure needle diameters?

I tried that but wasn't sure I did it right. Care to elaborate on how you
"measured?"

Michael Keller

|-----Original Message-----
|From: G.Penate [mailto:penate@home.com]
|Sent: Tuesday, September 12, 2000 1:30 PM
|To: pinhole-discussion@pinhole.com
|Subject: Re: [pinhole-discussion] where 2 measure needle diameters?
|
|
|Probably some of you are already doing the following, but it
|just occurred
|to me that a flat bed scanner can also be used to measure
|pinhole diameters.
|I just measured succesfuly a 0.012" pinhole diameter. My
|scanner is an "El
|Cheappo" UMAX scanner $60 and it was enough to do the job.
|
|Guillermo
|
|
|
Received on Tue Sep 12 13:35:11 2000