> I'm not sure this will help, but I have been pondering the slit problem.
> What if you used two single edge razor blades screwed to a board. You
could
> cut slots in them and have an adjustable slit that you could set with an
> automotive feeler gauge. If the razor blades do not give you a long
enough
> slit you could use wallpaper scraper blades (about 3" long). You would
have
> to do a little engineering, but that is right up our alley.
I believe Eric in his book, also suggest using razor blades, or maybe I read
it somewhere else, anyway, I thought in using the same 0.001" or 0.002" shim
stock to set the gap, but a feeler gauge idea is way better.
Guillermo
Received on Fri Sep 1 12:22:17 2000
This archive was generated by hypermail 2.1.8 : Mon 13 Dec 2004 - 23:15:55 PST