Re: Zero 2000 Zone Plate?

The second camera was all made out of 1/4 inch and 1/2 inch aspen from the
local home center. The tricky part was figuring out how to make the advance
knobs. They are made from drawer pulls. I mashed the screw heads down that
came with the knob to make film turners and added washers and springs. I wish
I had taken more care with the shutter, its tilted a little. I mounted the
zone plate and pin hole onto thin metal disks. There was a little gap in the
front where the extra lens can sit when not in use. My friend just got it in
the mail and loves it.

Andy Schmitt wrote:

> I would have sent this directly to Chris but his email address isn't on the
> note...
> Chris...I love the 1st camera...looks like my little cigar box creations..
> Did you make the interior on the second one or is it out of an old dead
> bellows camera?
> thanks
> andy
>
>

--
Chris Peregoy | http://www.gl.umbc.edu/~peregoy | http://imda.umbc.edu/